Difference between revisions of "CQM - record prelim config (MU3)"

From OpenEMR Project Wiki
Line 5: Line 5:


* You also have to make sure that you have a lab service created in the address book and a Procedure->Provider created for the procedure order to work correctly. Finally, make sure that your encounter codes are added to the Encounter Type list.
* You also have to make sure that you have a lab service created in the address book and a Procedure->Provider created for the procedure order to work correctly. Finally, make sure that your encounter codes are added to the Encounter Type list.
** Admin->Forms->Lists->Encounter Types then use the find code popup in the Code(s) column
** Admin->Forms->Lists->Encounter Types then use the find code popup in the Code(s) column and remember to click the Save button in the lower left corner.


=== Create/Find/Edit Person ===
=== Create/Find/Edit Person ===

Revision as of 15:57, 25 May 2022

Preliminary OpenEMR configuration

  • Externally data load the cqm valueset to use for the coding.
  • You may also have to install some CPT codes so please follow the licensing requirements for this and the previously mentioned valueset.
    • Admin->Coding->Codes
  • You also have to make sure that you have a lab service created in the address book and a Procedure->Provider created for the procedure order to work correctly. Finally, make sure that your encounter codes are added to the Encounter Type list.
    • Admin->Forms->Lists->Encounter Types then use the find code popup in the Code(s) column and remember to click the Save button in the lower left corner.

Create/Find/Edit Person

  • For this measure the denominator is looking for aged 18 years and older with a BMI documented during the current encounter or within the previous twelve months AND who had a follow-up plan documented if most recent BMI was outside of normal parameters.
  • Also check for Race and Ethnicity
  • Finally set up an insurance company and chose a CQM Source of Payment for that company and add it to the person's chart.

Find/Create encounter

  • Use the past encounters or create a new encounter

Encounter Performed

  • Under Visit Details select the appropriate dropdown from Type that corresponds to the code in the measure.